How to Fit a Geely Screen Protector: Starray & EX5 Guide

Tempered glass screen protector being fitted to a Geely Starray EM-i navigation screen

A scratch on your Geely's navigation screen is one of those things you can't unsee. Both the Starray EM-i and EX5 use large glass displays that pick up fingerprints, dust and fine scratches fast — a tempered glass protector stops that before it starts, and it only takes a few minutes to fit properly.

What You'll Need

Everything comes in the box with a proper screen protector kit:

  • The tempered glass protector (cut to size for your screen — 10.2" dashboard or 15.4" navigation)
  • A microfibre cleaning cloth
  • An alcohol wipe (usually included)
  • A dust-removal sticker (usually included)

You don't need anything else. No tools, no adhesive spray, no heat gun.

Step 1: Clean the Screen Properly

This is the step people rush, and it's the one that matters most. Wipe the whole screen down with the alcohol wipe first to lift oil and fingerprints, then go over it with the dry microfibre cloth. Any smear left behind will show up as a cloudy patch under the glass once it's on.

Once it's clean, use the dust-removal sticker to lift any last specks — do this in a closed car with the aircon off, not out in the driveway. Moving air is enemy number one here.

Step 2: Check Alignment Before You Peel

Dry-fit the protector over the screen first, with the backing film still on. Line it up with the edges and the camera or sensor cutouts (the Starray EM-i and EX5 kits are cut specifically for each screen, so it should sit flush with a small, even gap around the border). Note where the edges land so you're not guessing once it's tacky.

Step 3: Apply the Protector

Peel the backing film off and lower the protector onto the screen from one edge, letting it fall into place rather than dropping it flat. Most kits are tacky enough that light contact pulls it into alignment on its own — resist the urge to press down hard until it's centred.

Step 4: Push Out Bubbles

Use the microfibre cloth (wrapped over your fingertip or a card) to push air out from the centre toward the edges. Small bubbles near the border usually clear on their own within a few hours as the adhesive settles. If a bubble won't shift, lift that corner slightly and reseat it — better to do it now than leave it.

Common Mistakes to Avoid

  • Fitting it in direct sun or a hot car — the adhesive gets tacky too fast and you lose the ability to adjust
  • Skipping the alcohol wipe and going straight to the dry cloth — smears get sealed in
  • Pressing down before the edges are aligned — tempered glass doesn't reposition once it's fully seated

How Long Does It Take?

Around 5–10 minutes per screen if you follow the steps in order. Doing both the dashboard and navigation screens back to back takes about 20 minutes total, including cleaning.

Which Screen Protector Fits Your Geely?

We cut 9H tempered glass to size for the Starray EM-i and EX5's exact screen dimensions — anti-glare, anti-fingerprint, and sized to the pixel for a flush fit. If you're covering both screens, the screen protector bundle works out cheaper than buying the 10.2" and 15.4" separately.

Got a question about which size fits your model or model year? Reach out — we're always happy to help.

Back to blog