Installation guide — Geely Starray EM-i Outer Rear Bumper Protector

Carbon fibre pattern rear bumper protector being fitted to a Geely Starray EM-i

Your Starray EM-i's rear bumper takes a hit every single time you load the boot — trolley knocks at the shops, boots scuffing the edge, bag straps dragging across the paint. A bumper protector stops that damage before it starts, and it's a straightforward fit if you follow the steps in order.

What You'll Need

Just your RAVOX bumper protector and a few things you've probably already got at home:

  • Isopropyl alcohol wipe or spray (for cleaning the bumper surface)
  • A clean, lint-free cloth
  • Masking tape (optional, for positioning)

No drilling, no clips, no trim removal. The protector is a direct overlay that uses a high-strength adhesive backing.

Step 1: Clean the Bumper Surface

Wash the rear bumper area first if it's dusty or dirty, then let it dry completely. Once it's dry, wipe the section where the protector will sit with isopropyl alcohol and let that dry too — any leftover wax, dust or moisture will weaken the adhesive bond.

Step 2: Dry-Fit Before You Commit

Before peeling any backing, hold the protector in place against the bumper to check the alignment. It's shaped to follow the Starray EM-i's rear contour, so it should sit flush along the top edge with even overhang on both sides. If you want extra confidence, run a strip of masking tape along the top edge as a placement guide.

Step 3: Peel and Press

Starting from one end, peel back a small section of the adhesive backing and press that section firmly into place, working along the length in short sections rather than committing the whole piece at once. This gives you room to correct the angle if it starts to drift.

Once the whole piece is down, go over it again with firm, even pressure — palm or a cloth-wrapped squeegee both work — paying extra attention to the edges and corners, where lifting is most likely to start.

Step 4: Let It Cure

Avoid washing the car or driving through rain for 24 hours after fitting. The adhesive needs that window to fully bond — get it wet too soon and you risk the edges lifting before it's properly set.

Tips and Common Mistakes

  • Don't fit it on a cold morning if you can help it — adhesive bonds better above about 15°C, so an afternoon fit in the shade works best.
  • Skipping the alcohol wipe is the number one reason for early lifting — even a bumper that "looks clean" can have a thin layer of wax or road film on it.
  • If a corner does start to lift in the first day or two, press it back down straight away rather than leaving it — it won't fix itself.

How Long Does It Take?

Around 15 minutes from cleaning to final press, plus the 24-hour cure window before it gets wet. It's a one-person job — no second pair of hands needed.

Which Bumper Protector Fits the Starray EM-i?

We stock a carbon-fibre pattern ABS rear bumper protector cut specifically for the Starray EM-i's bumper shape — no trimming, no guesswork on fitment. If you're protecting the boot generally, it pairs well with our rear trunk mat for full coverage inside and out.

Got a question about fitting or compatibility before you order? Reach out — we're always happy to help. For details, please watch the video on YouTube

Back to blog